Description
Crocodile Epoxy-Seal is solvent-free, 2-component bonding, repairing, rebar anchoring and crack filling epoxy mortar, based on a combination of resins and specially selected high strength fillers. Its pasty consistency allows an easy and versatile application.
Advantage
• Non-sag product, even at high temperatures.
• Hardens without shrinkage.
• Excellent adhesion to concrete and many other materials.
• High early strength.
• High abrasion resistance.
• Solvent free.
• Can be cured under immersion.
Instruction
• All surfaces must be clean, free from dust and all loosely adhering particles.
• Cement laitance must be removed by mechanical means (i.e. sand blasting Primer is not required.)
• Mix both components together for at least 2 minutes with a mixing paddle attached to a slow speed electric drill (max. 600 R.P.M.) until the material becomes smooth into consistency and an even grey colour of the mixture is obtained.
• When using as a thin film adhesive, apply the mixed adhesive to the surfaces with a trowel, spatula or by glove-protected hand. When applying as a repair mortar, take into account any formwork that may be required. Max thickness in one layer is 30 mm.
• On vertical surfaces it is non-sag up to 10 mm thickness. On damp surfaces, ensure that the material is well rubbed in.
• Clean all tools and equipment immediately after use with thinner.
Substrate Preparetion
- All surfaces must be clean, free from dust and all loosely adhering particles.
- Cement laitance must be removed by mechanical means (i.e. sand blasting Primer is not required.)
Mixing
- Mix both components together for at least 2 minutes with a mixing paddle attached to a slow speed electric drill (max. 600 R.P.M.) until the material becomes smooth into consistency and an even grey colour of the mixture is obtained.
Application
- When using as a thin film adhesive, apply the mixed adhesive to the surfaces with a trowel, spatula or by glove-protected hand. When applying as a repair mortar, take into account any formwork that may be required. Max thickness in one layer is 30 mm.
- On vertical surfaces it is non-sag up to 10 mm thickness. On damp surfaces, ensure that the material is well rubbed in.
Caution
- Cement may cause injury to skin or eyes. Use of rubber gloves, dust masks, eye protection, and other safety equipment is recommended.
- If contact with eyes occurs, flush immediately and repeatedly with water, and then contact doctor immediately.
- Avoid contact with skin. Wash thoroughly after handling.
- Keep out of reach of children