Crocodile Plug

April 29, 2018 admin 0 Comments

Rapid Hardening Cement

  • Easy to use, just mix with water
  • Rapidly hardens within 30 sec to 3 min of being mixed
  • Excellent bond strength, pressure resistant
  • Can be applied in below 0 °c temperatures
  • Can be applied during leaking condition
  • No shrinking, strong adhesion; great for joining metal bars and dowel bars
Dimensions

1 kg, 4.5 kg

Compare

Description

Crocodile Plug is a ready-mixed, highly-accelerated underwater cement, scientifically formulated for quick repairs of concrete subject to hydrostatic pressure, active leaks, or underwater conditions. Plug sets quickly while bonding to the surface and expanding to rapidly block the flow of water.

Substrate Preparetion

  • Roughen the surface area with a wire brush, chisel, or by other mechanical means. Remove any loose or weakened concrete and mortar.

Proportion of Mixing

  • Crocodile Plug 4.8 kg per water 1 liter or
  • Crocodile Plug 4 part: Water 1 part (by volume)

Mixing

  • Mix Plug in a clean container with fresh, uncontaminated water. Mix ratio by voulme is approximately one part water to four parts Plug. Optimum water temperature is approximately 70°F (21°C). At temperatures above 100°F (38°F), mix with cold water to increase working time. At temperatures below 40°F (4°C), keep Plug temperature at approximately 70°F (21°C) by using warm water. Once water has been added, mix until material has attained a putty-like consistency. Shape the material to a form similar to the crack or cavity about to be repaired. USE GLOVES. Mixing time should not exceed two minutes. Never mix more than can be used within three minutes. Never add additiional water or retemper.

Application

  • Mix Crocodile Plug 4 parts with water 1 part by volume. Once Plug has achieved a stiff consistency and is shaped to fill the crack area, apply immediately. Force the material into the crack or cavity, compressing it firmly using a gloved palm, trowel, wood block, or other flat object. Hold it in place for over a minute. If there is a strong water flow hold for 5 minutes. Shave off any excess material with the edge of a trowel.

Caution

  • Cement may cause injury to skin or eyes. Use of rubber gloves, dust masks, eye protection, and other safety equipment is recommended.
  • If contact with eyes occurs, flush immediately and repeatedly with water, and then contact doctor immediately.
  • Avoid contact with skin. Wash thoroughly after handling.
  • Keep out of reach of children

Leave a Reply:

Your email address will not be published. Required fields are marked *